Page 1 of 1

Command Hooks not sticking

Posted: Thu Oct 11, 2018 10:55 pm
by Motörcrab
I'm having a problem with command hooks sticking on the inside of my tank in some areas. I tried a little water, vinegar, even a magic eraser to clean the inside glass. Then wiped it dry really well with paper towels before sticking them to the inside. After anywhere from an hour to a few days they will just fall off. I tried the hooks with clear rubbery and the white foam sticky pads and they keep falling off. This tank was originally an aquarium but we cleaned it out and scrubbed the entire tank very well before turning it into a crabitat.

The suction cups for my moss pit seem to be holding on fine, the occasional one may come loose every few weeks but thats it.

Any ideas what else I could try to get the command hooks to hold?

Re: Command Hooks not sticking

Posted: Thu Oct 11, 2018 11:02 pm
by fandt94
Following....I have the SAME problem

Re: Command Hooks not sticking

Posted: Thu Oct 11, 2018 11:35 pm
by ciaraalston
I had the same issue. I added a drop of aquarium safe silicone to the sticky part and let it set for a day or so. Mine have never fallen.
It also doesn't hinder removal. I just pull the tab and it pops off like normal.

Sent from my SAMSUNG-SM-N910A using Tapatalk

Re: Command Hooks not sticking

Posted: Thu Oct 11, 2018 11:36 pm
by ciaraalston
Also, I used the clear ones with metal hooks. Since March I haven't had any rust or problems with the metal hooks.

Sent from my SAMSUNG-SM-N910A using Tapatalk

Re: Command Hooks not sticking

Posted: Fri Oct 12, 2018 7:21 am
by RiNiKy506
ciaraalston wrote:I had the same issue. I added a drop of aquarium safe silicone to the sticky part and let it set for a day or so. Mine have never fallen.
It also doesn't hinder removal. I just pull the tab and it pops off like normal.

Sent from my SAMSUNG-SM-N910A using Tapatalk
Thank you for confirming that, I wanted to try it but I haven’t got around to it yet.


♡ Rod ♡ Salty ♡ Bob ♡ Squirt ♡ Crabina ♡
»-♡-> Our Purple Pinchers »-♡->

Re: Command Hooks not sticking

Posted: Fri Oct 12, 2018 7:58 am
by amandapri82
Great idea!

Sent from my VS996 using Tapatalk

Re: Command Hooks not sticking

Posted: Fri Oct 19, 2018 9:29 pm
by GotButterflies
ciaraalston wrote:I had the same issue. I added a drop of aquarium safe silicone to the sticky part and let it set for a day or so. Mine have never fallen.
It also doesn't hinder removal. I just pull the tab and it pops off like normal.

Sent from my SAMSUNG-SM-N910A using Tapatalk
Hopefully this isn't done with hermies in the crabitat. ;)

A few suggestions: try cleaning the surface with plain vinegar prior to placing the command hook. After cleaning it, wipe it dry with a plain paper towel. Then, press the command hook on, and press it and apply pressure for a good 30 seconds. DO NOT hang anything from it for a good 5 minutes. This works for me. :) I personally have used the velcro backing for hanging 9lb picture frames, and then I use whatever kind of command hook I prefer. My humidity is always at 99%, so that is never a factor for me. Good luck!

Re: Command Hooks not sticking

Posted: Fri Oct 19, 2018 9:33 pm
by ciaraalston
GotButterflies wrote:
ciaraalston wrote:I had the same issue. I added a drop of aquarium safe silicone to the sticky part and let it set for a day or so. Mine have never fallen.
It also doesn't hinder removal. I just pull the tab and it pops off like normal.

Sent from my SAMSUNG-SM-N910A using Tapatalk
Hopefully this isn't done with hermies in the crabitat. ;)

A few suggestions: try cleaning the surface with plain vinegar prior to placing the command hook. After cleaning it, wipe it dry with a plain paper towel. Then, press the command hook on, and press it and apply pressure for a good 30 seconds. DO NOT hang anything from it for a good 5 minutes. This works for me. :) I personally have used the velcro backing for hanging 9lb picture frames, and then I use whatever kind of command hook I prefer. My humidity is always at 99%, so that is never a factor for me. Good luck!
Oh no, definitely way before. Image Those spoiled babies get everything set up before they even get in there. Image

The totes will be much easier because instead of command hooks, I can just drill a small hole and zip tie.

Sent from my SAMSUNG-SM-N910A using Tapatalk

Re: Command Hooks not sticking

Posted: Sat Oct 20, 2018 11:10 am
by GotButterflies
Glad to hear that! Just wanted to mention in case others thought it was safe. No glues can be used when crabs are in the tank. Glues have to be completely dried before placing in the tank. :) (This is for everyone that reads the threads)

Re: Command Hooks not sticking

Posted: Tue Oct 23, 2018 9:09 pm
by Motörcrab
Thanks, Thats what I thought about the glue. I have been meaning to post a reply to this for a few days, every time I get side tracked. I had an extra suction cup or two laying around from a pet hammock i'm not using. I put a zip tie though it and it holds the wheel in place. Every few days I need to stick it back up. At least the crabs aren't knocking the wheel over every night now.