Page 1 of 1

Advice on mixing sand into tat

Posted: Thu May 07, 2015 2:16 am
by Tarn
Hi everyone,

I have been told that I need to mix some sand into my substrate. What type of sand should I get and can you suggest how to go about mixing it in. I have one little crab down moulting.

Thanks
Tarn

Re: Advice on mixing sand into tat

Posted: Thu May 07, 2015 2:30 am
by wodesorel
What kind of substrate are you using now? It may not be possible to mix it in until your molter comes up.

Re: Advice on mixing sand into tat

Posted: Fri May 08, 2015 5:40 am
by Tarn
Hi, I just have Coir in there. What if I put the sand on top and let the crabbies work it through as they are digging around?

Re: Advice on mixing sand into tat

Posted: Fri May 08, 2015 12:11 pm
by CallaLily
That would be fine. Just be sure to slowly add it a little at a time so you don't accidentally collapse any tunnels. Your crabs will mix it up eventually or once their all up you can just give it a good mix. Make sure you pick up play sand, not any calcium-type sand.

Re: Advice on mixing sand into tat

Posted: Wed May 13, 2015 9:27 pm
by Tarn
Thanks :)