It's been a while since I posted here, but don't worry, I'm still avidly crabbing!

I built the DIY humidifier this afternoon and I don't seem to be getting as good of results as a majority here. I have two tubes - one from the pump to the air stone in the water, and the other from the water to the tank. I have a pump that pumps 1200cc/minute and the water doesn't seem to be going up the tube...and all the holes are sealed.
Anyway, even when I put the tube all the way in the water, it fills halfway with water but doesn't go all the way up and out the other end. Only when I squeeze the bottle does the water go through the tube enough to go into the tank. Is there something else I should be doing to create more pressure on the inside of the bottle to make the water travel through better?
Also, should there be a light source anywhere near where the water should be coming out of the tube to create more humidity? Or no?
Any help would be awesome. Sorry for all the questions!
